The window glass is damaged, to change and the original window glass curvaturelike glass, at the same time to check the glass guide groove and a sealing strip is damaged. The window was repaired, often can not reply to the original shape,therefore, in addition to ensure that can easily pull or lift window glass, you should also pay attention to the sealing of the window around the window closed.

         In the roof, the roof should be in the surrounding pressure place coated with a layer of conductive sealant for welding, then painted over the edge glue in watertank and joint, which is sealed to body, it can prevent the body flange weld due towater

While early corrosion. Assembling the door when the window below the inner door panel is pasted on the whole sealing isolation film, if the seal film without forming,are available to replace the ordinary plastic paper, then the sealing film pastecompaction, and finally to trim production assembly.

        A sealing flange door in the repair of the sealing flange, should pay attention to the repair of damaged, accurate restoration of the original flange shape. If you pull thepaper required too much force that sealed tight, it will affect the normal close the door, and may also make the seal due to excessive deformation surface quickly lostfor sealing performance; if the force required to pull the paper is too small, the seal is bad, often can appear the phenomenon of the door does not rain. In replacing door must pay attention to apply glue in the inner and outer plate flanging foldingocclusal car door, and some left in the stamping process of small hole with the basetape block. Repairing the car line, should be all body hole, hole in the sealing ring is arranged in the wiring harness, because the sealing ring is not only play the role of sealing, but also protect the function of harness.

         Repairing the car line, should be all body hole, hole in the sealing ring is arrangedin the wiring harness, because the sealing ring is not only play the role of sealing,but also protect the function of harness. If the seal is damaged or the wiring harness can rotate or move in the sealing ring, you should replace the seals, and compared it with the body orifices, the assembly is firm, stable will harness.

         In the replacement of the entire body, except should complete the projects, but also in the overlapping portion of the weld and weld are coated with a layer of sealant,adhesive layer thickness should be about 1mm, and the adhesive layer may not have virtual sticky, bubbles and other defects; in the edge should be coated withspecial hemming adhesive; the floor surface and the front wheel housing should beelastic coating and anticorrosion coating of 3mm-4mm surface; Li to paste thesound and heat insulation, vibration damping film surface plate surface and the front on the floor, and then covered with insulation block, then covered with carpetor decorative floor. Corrosion rate of these measures can not only greatly enhance the vehicle sealing and slow down the body, but also can greatly improve the ride comfort.